GLOSS ALUMINIUM BLUE GEM

Here are the key features of the film we offer

• Thickness of film is 0.15mm. The film is thick enough to ensure protection.
• It is advanced polymeric multilayered film with silver coating and air release channels that help to achieve smooth application and perfect finish.
• Variety of colors: GAL01 True Blood, GAL02 Blue gem, GAL03 Candy purple, GAL04 Deep pink, GAL05 Mermaid green, GAL06 Paprika orange, GAL07 Leaf green, GAL08 Amber gold, GAL10 Storm Gray, GAL11 Silver mist, GAL12 Yellow green, GAL13 Olympic blue
• Width & Length: 1.52m*18m (59.8"* 708,6", 4.98ft*59ft, 1.66yd* 19,6yd)
• Adhesive is solvent polyacrylate. TeckWrap high-tech adhesive is save for car paint and has low or moderate initial tack ensuring easy installation.
• Release liner: Kraft white silicone-coated; paper with double-sided polyethylene coating. We care even about backpaper we use. Quality paper saves adhesive and material during storage and transportation. Storing period (shelf life) is 2 years if stored in +10°С to +20°С, relative humidity 50%, in original package, away from direct sun light, in clean and dry place.
• Average indoor life is 4 years and outdoor life is 3 years when followed rules of application and usage. Mentioned periods are enough for a car wrapping film. An adhesive usually becomes permanent on the post heated surfaces after 3 years, so we recommend unwrapping a car after this period to avoid cleaning of excessive adhesive residue.
• Recommended room temperature for application is from +17°С to +25°С. Service temperature is from -55°С to +65°С. TeckWrap car wrapping film is durable to temperature extremes, but we request customers to take care of it as if it’s original car paint. Don’t leave your wrapped car under direct sunlight for long period in order to prolong period of exploitation and ensure dimensional stability. Shrinkage is less than 3% for matte films, 4% for gloss films.
• Application method is standard one, suitable for polymeric calendared and hybrid films. General recommendations are thorough cleaning, no overstretching and post heating to recommended temperatures - 100℃ for flat surfaces and 120℃ for curves and overlaps. We recommend steam vacuum or IRR heater for installation.
• Cure time is 24 hours above 15℃ but we recommend keeping vehicle in room temperature for 48 hours to ensure maximum adhesive activation.
• Aftercare: PH neutral products. Avoid hot wax or solvents.